ICT-Up60-L05-KP2 0,16
Interface Materials/ Phase Change Materials
The latest generation with a 40% better performance in the total thermal performance
Based on the principles of Kapton MT® + (Dupont), but with almost double of thermal conductivity compared to the standard Kapton MT series the ICT-Up60 SERIES utilizes the combination of the benefits of prosperous manufacturer Phase Change technology and its increased efficiency in the polyimide film technology.
By the development of this unique formulation, the phase-change compound already provides a very efficient thermal transmission through phase-change at normal operating temperatures, while maintaining a uniform bonding line during the expansion process.
With the result that the air is expelled efficiently and surface irregularities or flatness conditions exist across the interface also can be minimized.
The ICT-Up60 SERIES can be produced in two different thicknesses and therefore comprises a total of two units:
ICT-Up60-L05-KP1 und ICT-Up60-L05-KP2
General Properties | Unit | ICT-Up60-L05-KP2 |
---|---|---|
Phase-change material | - | Silicone-free paraffine wax |
Color | - | Yellow|Gelb |
Material gauge with coating (µ) | µm | 76 |
UL flammability rating | UL | 94 VO |
Layer thickness of wax coating | µm | 12,50 per site |
Tensile strength | MPa | 186 |
Young's Modulus | MPa | 4,100 |
Dielectric strength | kV (AC) | 10,2 |
Volume resistivity | Ω/m | 10,00 ^15 |
Thermal conductivity | W/m*K | 0,85 |
Thermal resistance (inch² / 645,16mm²) | K/W | 0,16 |
Phase-change temperature | °C | 60 |
Operating temperature | °C | from -60 °C to 140 °C |
Storage temperature (max) | °C | 20 - 25°C |
Properties
- Silicone free
- Guaranteed Layer Thickness
- Cost-effective drop-in-place solution
- Fully customer-centered for specific requirements
- Low Thermal Impedance
- Excellent mechanical and electrical insulating properties
- Solutions for many types of surfaces
- Excellent replacement for thermal paste
- Only low tightening torque required
- Fast, clean and process-safe pre-assembly by partial adhesive strips on the outside areas of the Tims
- Material can be interchangeable without surface treatment
- Easy cleaning by Isopropyl alcohol
- Non-combustible according to UL 94 V0 Kapton MT+ UL registration (file.-No. E39505 du Pont)
Delivery Forms
- Other coating thicknesses can also be requested on request
- Roll lengths and widths available according to customer requirements (from 12 mm width, tol: +/-0.5 cm)
- In roll form, dimensions according to customer specification (drop & place) with or without partial adhensive liner both variants available on reel, also available unilaterally
- Fast, clean and process-safe pre-assembly by partial adhesive strips on the outside areas of the Tims
- Standard sheet Sizes-sheets | Standard DIN A4/30cm x 24inch or 39 cm x 60 cm (tol: +/-0.5 cm)
- In blanks and shapes according to customer specification sheet/roll/loose or on carrier (Kisscut)
- Depending on customer requirements
* The unilaterally applied adhensive liner layer (acrylic adhesive layer) increases the Rth value by up to 0.05 ° K/W
No warranties or liabilities can be taken for the displayed information.